Our revised hanging system is targeted around a vertical sliding sytem. This concept incorperates a system of pre-fabricated steel beams that have a notch cut down the length of them. This allows the TC panel to slide into them with the introduction of T-shaped gliders located on the back of the panel in line with the structural webbing. The panels are then supported by a steel dowel that intersects the beams but rests under a rounded nothch on the TC glider. This allows for the panels to hang on the beam at desired locations.

The panels can be lifted by two workers on either side and then placed into the steel beams. As they slide the panel down the steel track they are then set in place with the introduction of the steel dowel. All edges on are now tappered to allow easier Ram Press manufacturing. All edges have also been fillet in order to prevent any weak corner spots in the panel.